Power-acoustik PADVD-220 Manual do Utilizador

PADVD-220/ PADVD-220T Single-DIN A/V Multimedia Source Touch Sensor DVD/CD/MP3/MP4 AM/FM Radio Built-in TV tuner

Page- 9 General Operations Reset the Unit In case the unit is malfunctioned or need to reset to factory default setting, press RESET button in inn

Page -10 Digital Tuner Band selection Press MODE button to select the RADIO mode. Press the BAND button to select the desired band: FM1=> FM2

Page- 11 SD/MMC Cards & USB Operations USB Flash Memory To play MP3/ MP4/ WMA files from a USB flash memory, insert a USB flash memory into the

Page -12 Repeat Press the RPT button on remote control or the panel for RPT1 (repeat the current playing file) => RPT ALL (repeat all folders)

Page- 13 Discs operations Glossary PBC (Play Back Control) Play Back Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the di

Page -14 Playing/pausing To ensure good system performance, wait until the unit finishes reading the disc information before proceeding. Press th

Page- 15 PBC (Playback Control) function (for VCD only) If you insert a VCD with PBC, playback starts from the beginning of the 1st track automatic

Page -16 MP3 overview Notes on MP3: z MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. z This produc

Page- 17 Setup Menu • Press SETUP button to enter the system settings main menu; • Press cursor / buttons to move along icons on the top nav

Page -18 Dolby settings Menu entry Dual mono With this menu item you can select the type of Left and Right channel audio output. Stereo is nor

Page- 1 Table of Contents Table of Contents...

Page- 19 Menu entry Function TV Type This setting enables the selection of the appropriate TV standard. PAL is the customary standard in Europe. NT

Page -20 TV OPERATIONS (TV function is for PADVD-220T only) Connect TV antenna as it is shown on electrical connection diagram. Switch to TV mod

Page- 21 Note on Discs  Only use groundless loudspeakers.  Use only loudspeakers of minimal 40 Watt, using fewer watts may result in damaging

Page -22 Troubleshooting guide Symptom Cause Solution General No power The car ignition is not on. The fuse is blown. If the power supply is p

Page- 23 Specification General Power supply: 12 V DC Current consumption: max. 10 A Maximum power output: 40W x 4 channels Compatible formats:

Page -2 Important Safeguards z Using the device at temperature below -10 may cause the breakage of the device. BEFORE ℃USING PLEASE HEAT UP THE

Page- 3 Accessories Package contains the following accessories for installation and operation of the unit. (1) Washer, Spring Washer, M5 Nut 1 each

Page -4 Installation/Un-Installation First complete the electrical connections, and then check them for correctness. Installation This unit can be

Page- 5 Wiring Connections Make sure you have good chassis ground. A good ground connection will eliminate most electrical noise problems. A good c

Page -6 Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied power cord. C

Page- 7 Panel Controls 1. Power/Mute 2. BAND 3. PREVIOUS 4. VOL + 5. NEXT 6. DISP 7. AS/PS 8. LCD 9. IR sensor 10. OPEN 11.MODE.

Page -8 IR Remote Control REPLACING THE BATTERY Remote Control comes with a CR-2025 Lithium Battery included. 1. Remove th